Heat conducting films manufactured by a special process with copper
(electrolyte) on one side. The beneficial properties of the heat-conducting
film and copper create entirely new application possibilities, for
example, active EMC protection or as system carriers of electronic
switches.
The following copper tape/copper layer thicknesses
are available: 17µm, 25µm, 37µm, 50µm, 75µm and 101µm
Keratherm
Copper as a system carrier of electronic circuits
On
these system carriers, power densities of 5-10W/cm² can be realized.
In this case, the heat conductive silicone
film carries the electrical conducting
circuit paths in copper etching technique. The second conducting path
layer, for example in resistors,
capacitors or coils, can be produced
by applying polymer paste pressure.
In contrast to conventional circuit
board technology, this method allows efficient production from a roll.
The outstanding flexibility of the film permits the formation of interfaces
and cable harnesses.
These
system carriers for electronic
switches represent state-of-the-art design from an economical and
ecological perspective.
86/77
Datasheet
On
these system carriers, power densities of 5-10W/cm² can be realized.
In this case, the heat conductive silicone
film carries the electrical conducting
circuit paths in copper etching technique. The second conducting path
layer, for example in resistors,
capacitors or coils, can be produced
by applying polymer paste pressure. 
