-
Standard Films
The surface of the Keratherm white, green, pink, red and brown standard films is smooth in order to ensure that there is no entrapped air that would interfere with the heat transfer between the component and the heat sink. The material smooths out any microscopic irregularities in the contact surfaces which improves the thermal interface and therefore increases the heat dissipation.
-
Flexible Thermal Circuits (FTC)
Keratherm Copper films are heat conducting films with copper film on one side produced by a special process. Possible applications are, for example, active EMC protection or as a system carrier for electronic switches. A tailored polymer paste system guarantees a wide scope of applications.
-
"Phase Change Like" Films
Keratherm introduces two new films, 86/114 & 86/117, with "Phase Change Like" characteristics. No waxbase means less mess and no dripping. These films exhibit excellent thermal and electrical characteristics with compressibilities starting at 40°C up to 80%.
-
Flowtherm® Phase Change Materials (PCM)
Keratherm Flowtherm® Phase Change Material comprises a combination of hot-melt waxes with or without a carrier material. These films smooth out even the smallest irregularities between the power module and the heat sink and thereby improve the contact between the surfaces and increase heat transport.
-
Softtherm® Gap-Filler
Keratherm Softtherm® Gap-Filler is the ideal material for smoothing out even large component irregularities. Thanks to their outstanding compressibility, they produce an optimal thermal contact while at the same time being electrically isolating. The supplied thicknesses range from 0.5-5.0mm. Other thicknesses or shapes are available on request.
|
-
KoolBond™
A compliant metallized polymer matrix that is impregnated with a pressure-sensitive resin. The peel and stick silicone copolymer resin is compatible with chip mold release agents for additional strength. The metal matrix consists of a copper base and a nickel surface, which provides a corrosion barrier against aluminum.
-
Thermoplastic Polyurethane Films
Thermoplastic polyurethane tape with very good isolating behavior and excellent mechanical properties and good thermal characteristics
-
Silicone-Free
Keratherm silicone-free standard films are used wherever the use of silicone can lead to problems. Besides good thermal and outstanding electrical properties, these foils are characterized by their good cut-through resistance.
-
Sealing Compounds
Keratherm Sealing Compounds can be used for encapsulating whole applications and dispensing housing lids or heat sinks. Thanks to its ease of use, it allows even the most complicated geometries to be encapsulated.
-
Thermal Grease
Keratherm Thermal Grease is characterized, in particular, by its good plasticity and very low thermal resistance. No drying, or leaking out of the silicone components.
-
Adhesives
Every film type requires its own special adhesive system. Besides flexible adhesives with low strength, Keratherm Adhesive Coatings offer high adhesive strength or with various fillings for improved heat transport.
|
